View previous topic :: View next topic |
Author |
Message |
bencar
![](images/avatars/169031142644f4f030873c0.jpg)
Joined: 28 Jun 2006 Posts: 125 Location: New Jersey
1976 TransAm
|
Posted: Sat Feb 20, 2016 10:58 pm Post subject: Speedometer Jumping |
|
|
I have replaced the Driven Gear that had the end of the shaft melted off by the Cable, replaced the Cable, and now the Head, which started making noise after I replaced the Driven Gear and Cable.
The new Speedometer Head is quiet, but below 20 MPH, it has the jitters, and over 20 MPH, I'm not even sure if it's reading right. Could the new Cable, which did not match the old Cable length be at fault? _________________ Ben Deutschman
President Of The NY/NJ Slant-Six CLub of America
POCI Legislative Liaison
http://bencar.freeyellow.com/76TAPage.html
http://www.poci.org
http://bencar.freeyellow.com/benscarpage.html
http://clubs.hemmings.com/nynjslant6 |
|
Back to top |
|
![](templates/subSilver/images/spacer.gif) |
Larry Site Admin
![](images/avatars/980863097447eed2cb09ef.jpg)
Joined: 01 Jun 2006 Posts: 4773
|
Posted: Sun Feb 21, 2016 12:27 am Post subject: Speedometer Jitters |
|
|
Was the new cable longer? If so, it could be putting stress on the speedo head. Shorter shouldn't affect anything as there is plenty of room for everything that slips together. _________________ PontiacRegistry.com... building the single largest source of Pontiac information, services, and entertainment in the world! |
|
Back to top |
|
![](templates/subSilver/images/spacer.gif) |
bencar
![](images/avatars/169031142644f4f030873c0.jpg)
Joined: 28 Jun 2006 Posts: 125 Location: New Jersey
1976 TransAm
|
|
Back to top |
|
![](templates/subSilver/images/spacer.gif) |
Larry Site Admin
![](images/avatars/980863097447eed2cb09ef.jpg)
Joined: 01 Jun 2006 Posts: 4773
|
Posted: Sun Feb 21, 2016 10:29 am Post subject: Speedo Cable |
|
|
Oh. I thought perhaps you had only replaced the inner cable, and it was a tad longer. That could have been an issue. However, if you replaced the entire cable assembly and it was slightly longer, I don't see how that would be a problem.
One would think the new assy. would be lubricated, but pulling the inner cable out and putting on some lithium grease sure couldn't hurt.
Did you secure the cable, especially where it loops extra length. Although I don't really think it could be "hopping" any.
Usually a bouncing needle is in the speedo head, as they work with magnetism. It sounds more to me that the new speedo head isn't working right/well. _________________ PontiacRegistry.com... building the single largest source of Pontiac information, services, and entertainment in the world! |
|
Back to top |
|
![](templates/subSilver/images/spacer.gif) |
bencar
![](images/avatars/169031142644f4f030873c0.jpg)
Joined: 28 Jun 2006 Posts: 125 Location: New Jersey
1976 TransAm
|
Posted: Sun Feb 21, 2016 11:28 am Post subject: Re: Speedo Cable |
|
|
Given the other Cable was the original Cable, plus part of the driven Gear was melted to it, I wasn't taking chances, and replaced the Cable assembly, not just the inner Cable. I did make sure to secure the Cable, and at first, with the old Speedometer Head, everything was fine, then the original Speedometer Head started making noise, so yesterday I swapped it out. What a p.i.a that job is.
Now the new Head is quiet, but it has those issues I mentioned, and now EVERYTHING from the driven Gear out, is new.
Larry wrote: |
Oh. I thought perhaps you had only replaced the inner cable, and it was a tad longer. That could have been an issue. However, if you replaced the entire cable assembly and it was slightly longer, I don't see how that would be a problem.
One would think the new assy. would be lubricated, but pulling the inner cable out and putting on some lithium grease sure couldn't hurt.
Did you secure the cable, especially where it loops extra length. Although I don't really think it could be "hopping" any.
Usually a bouncing needle is in the speedo head, as they work with magnetism. It sounds more to me that the new speedo head isn't working right/well. |
_________________ Ben Deutschman
President Of The NY/NJ Slant-Six CLub of America
POCI Legislative Liaison
http://bencar.freeyellow.com/76TAPage.html
http://www.poci.org
http://bencar.freeyellow.com/benscarpage.html
http://clubs.hemmings.com/nynjslant6 |
|
Back to top |
|
![](templates/subSilver/images/spacer.gif) |
|
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum You cannot attach files in this forum You cannot download files in this forum
|
|